Plasmon Coupling-Induced Hot Electrons for Photocatalytic Hydrogen Generation

We present the fabrication of core-shell-satellite Au@SiO₂-Pt nanostructures and demonstrate that LSPR excitation of the core Au nanoparticle can induce plasmon coupling effect to initiate photocatalytic hydrogen generation from decomposition of formic acid. Further studies suggest that the plasmon coupling effect induces a strong local electric field between the Au core and Pt nanoparticles on the SiO₂ shell, which enables creation of hot electrons on the non-plasmonic-active Pt nanoparticles to participate hydrogen evolution reaction on the Pt surface. In addition, small SiO₂ shell thickness is required in order to obtain a strong plamon coupling effect and achieve efficient photocatalytic activities for hydrogen generation.     

甲烷浓度对碳化硅基底金刚石薄膜摩擦性能影响

利用热丝化学气相沉积法(HFCVD)在碳化硅基底上制备金刚石薄膜,采用场发射扫描电子显微镜、拉曼光谱仪、原子力显微镜研究了在不同甲烷浓度条件下制备的金刚石薄膜表面形貌及物相组成,在干摩擦条件下通过往复式摩擦磨损实验测试并计算了已制备金刚石薄膜的摩擦系数和磨损率,结合物相分析及摩擦磨损实验结果分析了甲烷浓度的改变对金刚石薄膜摩擦磨损性能的影响。结果表明,由于甲烷气体含量的升高,金刚石薄膜结晶质量下降,薄膜由微米晶向纳米晶转变。摩擦磨损实验结果显示:3%甲烷浓度条件下制备的金刚石薄膜耐磨性较好,磨损率为2.2×10^-7 mm³/mN;5%甲烷浓度条件下制备的金刚石薄膜摩擦系数最低(0.032),磨损率为5.7×10^-7 mm³/mN,制备的金刚石薄膜的耐磨损性能相比于碳化硅基底(磨损率为9.89×10^-5 mm³/mN)提升了两个数量级,显著提高了碳化硅基底的耐磨性。     

Energy Spectrum Width and Nonequilibrium Energy of Rayleigh Waves Scattered on a Two-Dimensional Near-Surface Electron Layer

We obtain expressions for the energy spectrum widths of Rayleigh waves corresponding to their deformational coupling to Fermi and Boltzmann electrons in a two-dimensional layer near the surface of a semibounded solid. We evaluate the nonequilibrium energy of Rayleigh waves that depends on these widths and is caused by the same coupling to the corresponding hot electrons. We show that this energy is independent of the degeneracy degree of the electrons and is given by the mean energy of free Rayleigh waves heated up to temperature of the electrons. We find conditions under which the thermodynamics is determined by this nonequilibrium energy of Rayleigh waves in films of a certain thickness with Fermi electrons near the surface and by the equilibrium energy of bulk phonons in thicker samples. All the results are obtained using the Keldysh diagram technique applied to the case of semibounded media.     

Nickel Chloride Promoted Glaser Coupling Reaction in Hot Water

A Glaser coupling reaction of terminal alkynes in the presence of nickel chloride withoutany organics and bases in hot water has been developed, which produces the correspondinghomo-coupling products in good yields.     

Nuclear Excitation by X-Ray Emission of Femtosecond Laser Plasma

The proposed model of laser plasma emission spectrum formation enables us to determine the absolute value of the laser pulse to plasma emitted radiation conversion factor, profile of the emission spectrum, and frequency distribution of the intensity and energy in the emitted spectra. This is of interest for laser plasma diagnostics and provides a means for direct calculation of the number of excited nuclei in dependent on the parameters of laser pulse. This revised version was published online in August 2006 with corrections to the Cover Date.     

高能闪光照相对电子束参数的要求

对高能闪光机光源性能用Monte-Carlo方法模拟研究发现：并非击靶电子束半径越小、发射度越低, 闪光机的照相性能就会越好. 研究结果表明：为了使闪光照相图像视面上照射量分布比较均匀, 对束半径与电子束归一发射度有一个联合限制, 对于20MeV闪光机, 如果击靶电子束有效半径是0.12cm, 那么仅当束归一发射度≥550cm.mrad时,在2°内的照射量不均匀性才小于5%.     

牛顿环中心暗斑大小对测量结果影响的研究

本文分析了牛顿环中心暗斑大小对测量结果的影响,并给出了解决方法。     

“阳”加速器钼丝X-pinch初步实验研究

 在“阳”加速器上进行了直径分别为10, 15, 20 μm, 交叉角为32°,45°,60°的钼（Mo）丝X-pinch实验。“阳”加速器产生的电流峰值约520 kA，上升时间80 ns。实验中通过X射线功率谱仪和纳秒分幅相机等仪器对Mo丝X-pinch辐射特性进行了诊断。实验表明：Mo丝X-pinch过程中会出现多次X射线爆发，箍缩过程中产生的热点辐射出能量超过3 keV的X射线，探测到的最小热点直径小于30 μm。     

Succinic acid adsorption from fermentation broth and regeneration

More than 25 sorbents were tested for uptake of succinic acid from aqueous solutions. The best resins were then tested for successive loading and regeneration using hotwater. The key desired properties for an ideal sorbent are high capacity, complete stable regenerability, and specificity for the product. The best resins have a stable capacity of about 0.06 g of succinic acid/g of resin at moderate concentrations (1–5 g/L) of succinic acid. Several sorbents were tested more exhaustively for uptake of succinic acid and for successive loading and regeneration using hot water. One resin, XUS 40285, has a good stable isotherm capacity, prefers succinate over glucose, and has good capacities at both acidic and neutral pH. Succinic acid was removed from simulated media containing salts, succinic acid, acetic acid, and sugar using a packed column of sorbent resin, XUS 40285. The fermentation byproduct, acetate, was completely separated from succinate. A simple hot water regeneration successfully concentrated succinate from 10 g/L (inlet) to 40–110 g/L in the effluent. If successful, this would lower separation costs by reducing the need for chemicals for the initial purification step. Despie promising initial results of good capacity (0.06 g of succinic/g of sorbent), 70% recovery using hot water, and a recovered concentration of >100 g/L, this regeneration was not stable over 10 cycles in the column. Alternative regeneration schemes using acid and base were examined. Two (XUS 40285 and XFS-40422) showed both good stable capacities for succinic acid over 10 cycles and >95% recovery in a batch operation using a modified extraction procedure combining acid and hot water washes. These resins showed comparable results with actual broth.     

强激光远场焦斑重构算法研究

 通过CCD图像采集单元结合传统的列阵相机测量高功率固体激光器的远场焦斑分布，采用图像处理技术的边缘算子提取焦斑的几何中心，提出通过几何中心对心的焦斑嵌套重构算法，解决了光斑饱和时的对心难题，实现了快捷准确测量激光焦斑，为激光器的实时控制提供参考数据。